Geeetech

yes but I'm not sure that it is the version 3-1 used by the A10M. the manual is not the right one.

thank you william this is also my opinion. I'm going to ask geeetech for a little help and especially a 2560V3-1 circuit diagram

TNX William , it’s the same plugged or unplugged , I read 280° on the screen and the nozzle is OK . Have a good day.

Hello, on my A10M I have a problem heating the bed, it does not heat the screen indicates 280 degrees the resistances are good (2x3 ohm) as well as the thermistor (120k) all being measured at the main board . Do you have an idea ? Thank you

I deleted them because one lost during a cleaning. And since then I can't seem to have a good impression. Is there here any information on the setting of the A10M "cyclope heater"? Thank you.

Into the A10M heater there are a small screen mounted in the downed end of the throat. What is the using of this part ? Is somebody have tested to print without ?