Geeetech

@ Vert and Yan_UK - I'm in the same boat. Is there any solution to fixing the A30 is it just a boat anchor? Can't get a "good" print out of it to save its life, and we've done several upgrades including new hot end, Swiss made all metal heat choke, new all metal extruder, Creality bracing bars ...

the A30 will come with smartto firmware its considered to be garbage by most as far as marlin 2.0 it runs on the board but the screen is closed source also so it isn't supported.


Why did Geeetech do this? Surely it would have been seen to be a more superior printer and should have had better ...

Hi there. Thanks for the post. I did all you said, but still finding problems. When I level all 4 corners, than the middle will be too tight. If I level the middle, than the 4 corners will be too loose. Any advice please? Still haven't manage to print anything yet. Thanks.


I have experienced ...