Hello William,
thank you very much for your immediate reply, but in the "Slicing Settings"-Tab there is no general "print speed" available, but all these (see picture).
Could you please again have a look and precise which of these I have to change?
Thanks again a lot.
Search found 2 matches
- Tue Feb 18, 2020 5:47 pm
- Forum: Geeetech I3 Pro W
- Topic: Printed Vase.stl file looks a bit strange
- Replies: 4
- Views: 7048
- Sat Feb 15, 2020 6:42 pm
- Forum: Geeetech I3 Pro W
- Topic: Printed Vase.stl file looks a bit strange
- Replies: 4
- Views: 7048
Printed Vase.stl file looks a bit strange
Hello,
I got a Prusa I3 Pro W and it was a nice job to assemble it. After everything seemed to be well done I printed the job vase.stl with the default settings. The software is EasyPrint 3D Version 1.2.6 and Firmware is V1.0.05.
The result looks a bit strange, the surface is not dense and compact ...
I got a Prusa I3 Pro W and it was a nice job to assemble it. After everything seemed to be well done I printed the job vase.stl with the default settings. The software is EasyPrint 3D Version 1.2.6 and Firmware is V1.0.05.
The result looks a bit strange, the surface is not dense and compact ...