Geeetech

Have you got the share one heater activated in the printer settings in Cura?

The firmware being the one I have.. do not know the one you have, but will look

can you post a link to it

Hi William, I am getting there, it was an error in my firmware I had.
but thanks for the feedback

Hi, I do believe I have sorted it,

First there is a problem with the Firmware. In the configuration.h.

Have a look in Ardiuno and find the section

/**
* "Mixing Extruder"
* - Adds a new code, M165, to set the current mix factors.
* - Extends the stepping routines to move multiple steppers ...

Yes I did, It is showing two hotend in the display.

Hi,

after doing a mod of a 2in 2out hotend upgrade that went really well, I cannot get the second extruder to work after slicing in Cura and in RepetierHost.

I have tested both extruders using RepetierHost sending a command and both work, so that means power is there.
I have changed both ...

Has the problem with the Extruder been solved? I have made the changes to my A10M, upgraded to a 2in 2out extruder/hotend and only one extruder is being used to print.

starting to baffle me
thanks