Geeetech

Thanks for your reply!
Today I just turned it on and was going to just leave in on for a few hours. After something between 2 1/2 (last time I checked and nothing happened) and 3 hours everything was back to normal... I don't have any clue what was wrong. I did not touch that crazy thing at all.
No ...

Hi there,

So my A10M only shows 2 lines of blocks on the LCD.
I know, there are other threads with this topic, but none of them could eventually solve my problem.

It printed fine, I turned the printer off and the next day this came up when I turned the printer on. I have not touched the printer ...

So, I printed a few things after switching the SD-Card and there have been no failed prints so far. Might really have been that easy. Again thank you for your help!

Now this thing has another problem, I can't figure out, but I will open another thread for that.

Yeah, Octoprintis something I already wanted to tackle, but you know... time and motivation :D I'll see with that.

Actually had a "failed" print again, but as it turns out, your tip to load the file back to the pc might give a hint, what went wrong.

https://www.bilder-upload.eu/thumb/b935ef ...

Thanks for the reply!

I will try that as soon as it happens again. The print that ran while I was typing this yesterday, came out without problems of course :D
Do you mean load the gcode file into cura and look how the object looks or actually read gcodes? I have not gotten into this until now.
The ...

Hi there,

I've run into something very strange... My printer has started to just randomly "print" stuff, whenever it get's close to 95-97% of its print job. The nozzle even goes into the print, destroying it. I just can't figure out, what causes this.
Also it doesn't really end the job, the ...