Geeetech

I guess that a no?
Amazon is out of nozzles and shipping from China is well to long .

Is there any nozzles that fit, I tried amazon and the threads seem right but the tip end is only 6mm , the factory nozzles were 7mm.

Buy a new hotend ?

I have a stock a10 .
I’m printing PLA
PrusaSlicer
I’ve tried 195 thru 210 and various speeds from 20-50.

Even if I have supports everywhere it droops and is inconsistent,about have the time it is incomplete.

Is it a cooling issue or something else.

vert wrote: Fri Mar 13, 2020 7:36 am drop in tmc in standalone mode.

That is very cryptic answer.
I want to use your latest build, I guess you need to download vscode and an extension?

Probably the tmc2208.
Good luck finding out how to install them correctly.
You need to update firmware or change the pin out on the board plugins .

I was given this info by a geeetech employee , but I don’t think it is correct. It’s a picture of the pin layout.
But I don’t have a hosting service .

A full recompile. this is my first printers, Thats way beyond me !
I would not know anything about that....so basically your saying I'M screwed.

the home position is 14mm to the left of the bed and the x is 6mm to the front.
as soon as a print is started it tries to lay a purge line, but the bed to offset and it printing and oozing and creates a mess.

how can i adjust the home position.