Geeetech

Hi,
levelling hotbed is first I do before every print.
But it takes any effect.
What do you think about the problem with z- axis ?
How can the extruder be calibrated ?

Thanks

Hi William,
here is video which shows the issue.
The problem with z axis (autohome) happens sometimes , if I switch out printer for a longer time 2 hours or more or install the actual firmware again the problem disapears. But returns again, after a few trials.https://www.geeetech.com/forum/download ...

Hi,
I've got a A20 M since three weeks. And I've got massive issues with this printer.
I made the setup due to the instuctions but the printer doesn't work right.
One issue is that when pushing the auto home button , z axis steps up aproxamatly 1cm, this happens again and again while pushing ...

Hi William,
thank you for your reply.
That was the reason for faillure.
The printer doesn't work with the Cura Software.
I tried Cura 4.4 and new 4.5, with both the A20M won't work.
It would be fine to comunicate this issue in the quick start guide
,before anybody wasts a lot of time.

Michael

Hi,
got an new A20M since three days .
But my prints are not working because of the following issue.
When start the A20M will take all parameters from the gcode file .
In my special case
extruder temperature 240°C
heatbed 80°C
mixer 100%; 0%
I want to print with ABS in that special case.
So the ...