Geeetech

I printed three pieces a day without any problems. Then I turned off the printer.
The next day I turned on the printer ... but nothing happened. Printer is dead. When I connect it to the PC via USB, the display turns on, but the motors are not powered.
A quick check showed that the power supply was ...

Hi Wiliam,

I reinstalled the EasyPrint 3D program and the printer driver.
The result is the same. Slicing stops without an error message.

Wenn ich das Slicing mit Ultimaker Cura 4.5

If I do slicing with Ultimaker Cura 4.5 then I can easily load the *.gcode file.

I have linked the *.gcode ...

Hi William

the program always stops with the *.stl:
Program example files: deer.stl, case.stl
ASCII: comp01.dae_A.stl, test3.dae_A.stl
Binary: comp01.dae_B.stl, test3.dae_B.stl

I think the problem is not with the files.

-------------------
I am a newbie.
What you mean with "... use Repetier Host ...

Thank you for the quick and detailed answer.

Unfortunately, you have not yet understood the problem.

I see the latest / current version is V 1.0.05. I installed this version. You can see that in the window below
Installed Version: V 1.0.05
Version V 1.0.04 is older than V 1.0.05. Version V 1.0.04 ...

I have Windows 10.
Slicing seems to start correctly. Before the progress display starts, the EasyPrint3D program breaks down completely. Without an error.
The button Done! I can’t click. The gcode file is also not yet created.
What can I do?

What is the newest / most current version?

The Firmware Upgrador shows:

Installed Version: V1.0.05
Newest Version: V1.0.04

Installed is newer than the newest?
What is wrong?