Geeetech

Hi,

My A10 3D printer is broken.
The extrusor doesn't move.
I have to replace my mother board.
So Can you help me to find a new GT2560 V3.0 mother board?
Thank you

Din0 wrote: Mon Apr 27, 2020 12:55 pm https://github.com/Vertabreak/Marlin

Thank you, but I don't know how set up this firmware for A10 with 3d touch.

Could you help me, please?

thank you

Makusim wrote: Mon Apr 20, 2020 9:59 am How did you decide that? It works for me. Only you need to configure yourself through arduino

Hi,

Coul you send me the firmware merlin 2.0 3d touch for A10,please?

Thank you

Hi,

Topprinter what mode did you set up (Standalone, OTP or UART)?
If it works for XYZ then you might have a faulty driver or not connected properly, try swapping E with Z and see.

Cheers
Andrzej


I set up STANDALONE.
When I use TMC2208 the extruder motor doesn't move, but if i use A4998 the ...

I have A10 GT2560 v3, and the TMC2208 works only for X-Y_Z motors.
About the extruder the TMC2208 doesn't work, the motor doesn't move.

Could anybody help me? please

Hi,

Could be a problem of underextrusion , so maybe you could increase extrusion multiplier of about 5% and increase temperature of 10°C, and so on.
Howewer take care of bed leveling.

Good luck

hi,

Could I have the link to download Marlin 2.0 3D touch for A10 v.3 , please.
I can not find it.

Thank you very much

Hi,

I have the A10M and am attempting to upgrade the stepper drivers to the new BIGTREETECH TMC2209 v1.2. There is some info online and I'm following Teaching Tech's video here "https://www.youtube.com/watch?v=dOJbSrWVu_Q". I do not know how to wire the 2209 steppers to the GT2560 v3 board and do ...

Hi, you can try to reverse the direction of the motor of the extruder, check the situation,
If it still does n’t work,
It can be installed in the position of the extruder motor using A4998
maybe not saving the reverse setting of the extruder motor leads to.



done.

but the same, the extruder ...

William wrote: Fri Apr 10, 2020 3:05 pm Check if the drive board you inserted into the extruder is damaged

Ok.
I installed another drive TMC2208 , but the extruder doesn't move.
I tried to instal a new TMC2209, but the same the extruder doesn't move.

I don't kow what do...

Help