Geeetech

Hey William,
thanks for the answer, but I'm a bit confused now. In my case M303 does nothing. It didn't start any autotuning... That is my problem... Does the firmware normally react on that code?

Hey Folks,
i can see the PID values in the Smartto tool. But is there a possibility to do the PID Autotuning. I tried it with the M303 command, but that doesn`t work. And just changing the values is a bit too difficult to me due the fact I don't really know what kind of changes I should do. I need ...

Hey William,

I did that already... I have 320x320. And as I told you the strange thing is, when I manually move the hotend (with the geeetech control panel) I can't use the full range of the bed 'cause the X0/Y0 is off the bed in the air. So it's seems not to be a problem with the slicer...

I ...

Hey Folks,

I have a problem with my heatbed. The print is not centered... I'm using ideamaker and checked severel times the printer settings. But it seems to be fine.
When I travel manually with the "Move" buttons, I have offsets X appr. 15mm and Y appr. 30mm. So I don't think it's more than false ...