Geeetech

I got this from support, havent tried it yet and havent printed anything for awhile... I just started a print and came to the forums cause its been awhile.. could of tested it but i forgot.

From support
pls do leveling first , then heat up .


G28
G1 Z15 F300
M107
G90
M82
M104 S210
M140 S55
G92 E0 ...

I see the Geeetech video's that show how to do this, but they are older releases and the options are not the same..

Where to set infill % in 1.2.6 ??!?!?

Thanks.

Hi,

The A30t says the supported slicer is Repetier Host, and I loaded the config files... which I had to search for, being that it only give me the option of selecting 1 extruder with cura slicer, how do I add the other 2?
This is really holding up my prints, and need to get sorted so I can start ...

Hi,
I need A30t Profiles plz.. thanks.

How to select nozzel in easy 3dprint to print with, say I want single color from spool 2, and not auto 1 ..

Hi,
Looking for any and all Config files you guys might have for the A30T, for any and all slicers..
I'd like to play with as many as I can, but dont have configs for them all..
Not to mention the downloads page has it for only for Cura, and a video setup for Repetier Host.. that uses the Cura ...

Hi,
I bought the A30T, and I do no like how it starts the warm up process 2-3mm in the center of the print bed,
how or what can I add/modify to the g-code to make it do this in the safe position off the front of the bed?


Edit..

Actually I have a few requests that I would like to have.. if ...

Hi,

Bought the A30T, have it built and printing the the file on the micro sd it came with and seems to be going just fine,

however I am finding it amazingly hard to find all the info I need to setup either Cure, Slic3r .. Is there any that come with the A30T as a defined printer in it?

Just ...