Geeetech

before you change any hardware on your printer have you tried adjusting your 3d touch? it could be that where the printer thinks 0 is is much higher up than it is. I wouldn't recommend altering the hardware on the printer until you've done a fair bit of googling on your issue, I had many problems ...

Hello, my printer is the A10T, running Marlin 1.1.8 on a GT2560 V3. I bought it not too long ago so everything should be the newest version out of the factory.
I've had a few problems up to this point that I've managed to fix, so the firmware on the board is not what came installed, but now I'm ...

So before you say it, yes, I'm aware that there is already a forum post on how to fix this issue, however either I'm not understanding it correctly, or it does not include the material relevant to my printer, and pointing me to that forum is not helpful.
My printer is the Geeetech A10T, triple ...