Geeetech

Hello, thank you very much for your response. I am not super knowledgeable on this subject; this is my first 3D printer.

I do not know how to find, Sbymm, Mrev, Sang, or Mstep. However I found another post that accurately describes what I am doing. Here is the link to the bottom image attached ...

Hey, how can I change my z axis step value in the firmware using the Arduino IDE?

I actually have the opposite problem, where I need to change it from 2560 to 400.

Thanks,

-Tony

Hello,

I bought a I3 Pro B from a friend and noticed the previous rods where damaged due to lack of lubricant. I purchased new stepper motors (310mm lead screw length, 8mm diameter, 1.8 degree step angle).

I installed the new motors and steppers can move the extruder carrier up and down without ...

Hello,

I bought a I3 Pro B from a friend and noticed the previous rods where damaged due to lack of lubricant. I purchased new stepper motors (310mm lead screw length, 8mm diameter, 1.8 degree step angle).

I installed the new motors and steppers can move the extruder carrier up and down without ...

Hello,

I bought a I3 Pro B from a friend and noticed the previous rods where damaged due to lack of lubricant. I purchased new stepper motors (310mm lead screw length, 8mm diameter, 1.8 degree step angle).

I installed the new motors and steppers can move the extruder carrier up and down without ...