Geeetech

Ok i have it connected with the motherboard and the same result is nobady eabel to help me with that problem, Is it even possible that you can get it to work with a v4 motherboard.

thx

Don't work....

1.i install the firmware

2. i turn off the printer

3- i install the 3d touch

4.I pull the plug from the end stop / testet with and without... when it is plugged the led from the endstop is red

5. i start the printer and go to menu bltouch and test it.... no response

Ok .. i ...

Hi,

I have a problem with my A10 with a 2560 V4.0 board. I cannot find any firmware with 3D Touch support only for V3.x or for V4.1
I've tried these but it didn't work.
And I've tested with the A10T that support the V4.0 board, but it doesn't work, the 3D touch only makes the self-test pin in pin ...

Hi,

I have a problem with my A10 with a 2560 V4.0 board. I cannot find any firmware with 3D Touch support only for V3.x or for V4.1
I've tried these but it didn't work.
And I've tested with the A10T that support the V4.0 board, but it doesn't work, the 3D touch only makes the self-test pin in pin ...