default mix setting for A10M

[swolffke]

How can we set the default mix setting for the A10M? Where in the marlin firmware or through the menu?

Kr,
S

[William]

AS shown in the picture.
Mixer menu offers two mix-printing options, namely fixed mix ratio printing mode and Mix ratio printing mode that varies with height.

[swolffke]

AS shown in the picture.
Mixer menu offers two mix-printing options, namely fixed mix ratio printing mode and Mix ratio printing mode that varies with height.

yes, i found that but it does not get saved on power off/power on...

[William]

Hello, you need to save the settings in the interface shown in the figure below every time you change the printer settings.

[swolffke]

Thx William for the answering so quickly

it doesn't store the mixer settings for my A10M

that is why i am trying to find out in the source where it is...

[William]

Hello, you can add the following code to the star gcode of the slice software to save it.
M163 S0 P0.3
M163 S1 P0.7
M164 S4

[swolffke]

Thx William... did not think of that myself