This transistor acts as a 5V power key between USB and step-down converter on the controller board.
I can see that we are slowly approaching the solution of this riddle.
Do you sometimes have not set some kind of an offset
problem movement
Re: problem movement
This transistor acts as a 5V power key between USB and step-down converter on the controller board.
I can see that we are slowly approaching the solution of this riddle.
Do you sometimes have not set some kind of an offset
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: problem movement
No.
it looks like a "Home offset" ...
but I do not see where this one could be.
(I remember that it happened suddenly, without changing configuration)
it looks like a "Home offset" ...
but I do not see where this one could be.
(I remember that it happened suddenly, without changing configuration)
Re: problem movement
I remember.
You wrote that you were using a printer and after restarting the problem occurred.
Have you tried to view all settings in the operator panel
It is also worth trying (after the control) to save the settings again.
I also suggest to browse the firmware configuration. Didn't it crept in before the compilation of any mistake.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.