Page 2 of 2
Re: Y- Axis Failing
Posted: Mon Jun 15, 2015 9:37 am
by jfsgi
I got the error while trying to upload the firmware>
I loaded the .ino file into the software and clicked upload. (I think there was a total of 73 files that loaded in the Arudiono for the upload
Re: Y- Axis Failing
Posted: Mon Jun 15, 2015 9:48 am
by zhangxueyou
No, drag all the files into Arduino.
Re: Y- Axis Failing
Posted: Mon Jun 15, 2015 11:08 am
by jfsgi
All of the files are loaded into audrinio, 73 total
Re: Y- Axis Failing
Posted: Mon Jun 15, 2015 11:28 am
by zhangxueyou
Still displaying error? What version of Arduino are you using?
Re: Y- Axis Failing
Posted: Mon Jun 15, 2015 7:29 pm
by jfsgi
1.6.4
Re: Y- Axis Failing
Posted: Tue Jun 16, 2015 9:12 am
by zhangxueyou
Higher version doesn't have good compatibility, you can try to upload with Arduino1.0.1:
http://arduino.googlecode.com/files/ard ... indows.zip
Re: Y- Axis Failing
Posted: Tue Jun 16, 2015 9:20 am
by jfsgi
Loading via the lower version seemed to work,
I also have a problem with the slicer
I attached a photo of the issue
Please advise
Re: Y- Axis Failing
Posted: Tue Jun 16, 2015 9:29 am
by zhangxueyou
You can refer to this page to set your printer in Repetier first:
http://www.geeetech.com/forum/viewtopic ... 21&t=16512