Geeetech

_shorty_ wrote: Sat Nov 10, 2018 6:02 am I'm getting this error on arduino software version 1.8.7
U8glib.h: No such file or directory

Put this file in the library and try again,
Sketch->Include Library->Add .ZIP Library.

thanks!

_shorty_ wrote: Sat Nov 10, 2018 6:02 am I'm getting this error on arduino software version 1.8.7
U8glib.h: No such file or directory

You need to add the U8gilb on library manager(Arduino).Then it will work.

Someone modified the firmware for use with 3D-Touch and get it to work?

flat-jack wrote: Thu Nov 22, 2018 4:11 pm Someone modified the firmware for use with 3D-Touch and get it to work?

You need to check the hardware at first.
If the 3dtouch wires plug correct,the firmware needs to change.
1. Enable the auto level and set the correct value on configuration.h
2.Then you need to set the servo0 pin on board pins.h