Page 2 of 2
Re: A10M Stringing / Oozing (Same Settings - Different Results)
Posted: Fri Aug 30, 2019 4:15 am
by Tommies
Hello,
for my a10 i use
130 mm/s travel speed (but i'm going to try higer speed)
6000 mm/s retractation speed
Re: A10M Stringing / Oozing (Same Settings - Different Results)
Posted: Tue Feb 18, 2020 4:22 am
by toxic
I use PTEG and did a lot of calibrations but still have oozing. Did removing little disks from the hotend will solve that problem?
- IMG_20200215_191254.jpg (218.12 KiB) Viewed 5013 times
- IMG_20200217_212904.jpg (441.61 KiB) Viewed 5013 times
Re: A10M Stringing / Oozing (Same Settings - Different Results)
Posted: Mon Jul 13, 2020 6:45 pm
by pakbehl
This thread was quite helpful for me, I thought I'd try to contribute...
I'm curious to know if you found better solutions since the last post?
My suggestion at this point, given what I've seen so far, is that z-hopping should be the final solution to that pesky end-of-layer string if you can't get it fixed with retraction, temperature, speed, or altering the extruder path with combing, seam-hiding, etc.