Geeetech

Hi
Thanks for the reply Loboheat.

Didn't work!

I free the stepper motors, then move X to the far left and Y right back, I leave Z where it is.

When I send G28, X and Y move the there maximum and then tries to go further (loud jumping noise) and Z then comes down and touches the edge of the heat plate twice the stops.


Can I send G28 followed by G29, to see the probe pattern?

Cheers

ดูหนัง Netflix

Hi

Downloaded the files and Arduino 1.8.2, many thanks

Ver 2.0.6 won't compile, getting this error


Using library LiquidCrystal at version 1.0.5 in folder: F:\arduino-1.8.2\libraries\LiquidCrystal
fork/exec F:\arduino-1.8.2\hardware\tools\avr/bin/avr-gcc.exe: The filename or extension is too long.
Error compiling for board Arduino/Genuino Mega or Mega 2560.

Hi!

Install the library LiquidCrystal and try again.

Best regards.