Geeetech

So, first post updated with the bugfix-1.1.x-branch, fresh clone. Try it out and tell me if it works.

Don't forget M502 followed by M500. Some stuff have changed.

My only problem is that when i'm homing my extruder it's going to center of bed and i don't want that. I think that when homing extruder it should go in down left corner? My print starts from middle of bed and that's okay, but i want to change my extruder place when homing it. I have tried to change it with M206 command and saved it with M500 but it's still going to center of bed when homing?

I'm using Repetier Host and i can't change that homing place from it's setting either...

Turn off safe homing.

Thanks works perfectly. Just having problems with extruding, but let's see can i get it work.

i have an i3 Pro X, what to change to use this firmware ?

schlaubi666 wrote:i have an i3 Pro X, what to change to use this firmware ?

Hi,you can refer to this post:http://www.geeetech.com/forum/viewtopic ... 20&t=17046.

Sorry folks. I can't answer PMs or edit this thread. I changed the e-mail address for my NiklasO account and because of that the account got deactivated (administrator has to activate again). I have e-mailed Geeetech and spoke to them using Whatsapp but my NiklasO account is still deactivated since like 2 weeks now...

NiklasO2 wrote:Sorry folks. I can't answer PMs or edit this thread. I changed the e-mail address for my NiklasO account and because of that the account got deactivated (administrator has to activate again). I have e-mailed Geeetech and spoke to them using Whatsapp but my NiklasO account is still deactivated since like 2 weeks now...

Hi,I have contacted the administrator about your case.They have activated your NiklasO account.Please try to log in again.

William wrote:

NiklasO2 wrote:Sorry folks. I can't answer PMs or edit this thread. I changed the e-mail address for my NiklasO account and because of that the account got deactivated (administrator has to activate again). I have e-mailed Geeetech and spoke to them using Whatsapp but my NiklasO account is still deactivated since like 2 weeks now...

Hi,I have contacted the administrator about your case.They have activated your NiklasO account.Please try to log in again.

Thanks! I need to change the mail address again for this account. Please activate NiklasO and NiklasO2 again. Thanks!

Anyone got a working config for the new marlin 1.1.3 stable version ?