Re: electronic got fried
Posted: Fri Mar 20, 2015 5:55 pm
Did you choose correct board type(Sanguinololu W/AT mega1284p 16mhz) and serial port?
Do you use our firmware?
Do you use our firmware?
Geeetech
Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
https://forum.geeetech.com/
electronic got fried
Page 3 of 5
Re: electronic got fried
Posted: Fri Mar 20, 2015 6:00 pm
Yes the board and port were correct as well, but I got that error when I wanted to upload the firmware, I believe that the atmega1284p doesn't have a bootloader, thus I'm unable to upload the firmware
Re: electronic got fried
Posted: Fri Mar 20, 2015 6:14 pm
Did you install the driver?
If not, you should install it first.
If not, you should install it first.
Re: electronic got fried
Posted: Fri Mar 20, 2015 6:36 pm
Yes, driver properly installed without problems, no yellow exclamation mark. The usb cable are fine because there were no disconnections detected.
Pronterface unable to connect
Repetier host didnt show firmware details
Pronterface unable to connect
Repetier host didnt show firmware details
Re: electronic got fried
Posted: Fri Mar 20, 2015 8:26 pm
Yes, it has been installed, no yellow exclamation mark, com port also left as it is, during connection, correct com port also picked
Re: electronic got fried
Posted: Sun Mar 22, 2015 12:24 am
Yes i did, there were no problems with the driver, no yellow exclamation mark appeared in the device manager
Regarding my tech support on the board, how lomg am i supposed to wait? And another thing, how many posts should i submit to get the post approved. My supports are slow due to posts being approved at lower rate and yet, my time is running out in aliexpress. The wholr printer cannot function and testing it is impossible without the electronic
Regarding my tech support on the board, how lomg am i supposed to wait? And another thing, how many posts should i submit to get the post approved. My supports are slow due to posts being approved at lower rate and yet, my time is running out in aliexpress. The wholr printer cannot function and testing it is impossible without the electronic
Re: electronic got fried
Posted: Mon Mar 23, 2015 9:11 am
What is your computer system?
Re: electronic got fried
Posted: Mon Mar 23, 2015 10:01 am
windows 7 ultimate 64 bit
core i5
ati mobility radeon5650 1gb vram
4gb ram
500gb hdd
4 usb port
core i5
ati mobility radeon5650 1gb vram
4gb ram
500gb hdd
4 usb port
Re: electronic got fried
Posted: Mon Mar 23, 2015 10:12 am
Please refer to this page:
http://www.geeetech.com/wiki/index.php/ ... d_software
http://www.geeetech.com/wiki/index.php/ ... d_software
Re: electronic got fried
Posted: Tue Mar 24, 2015 8:10 am
The software failed to connect just like how I used the normal repetier host. Refer to the picture below
