Geeetech

I mean that i tryed what you sayed to swap motor x with extruder and it works, but when i try to print with the extruder in his own driver slot nothing happend.

Can you extrude the filament with your hand?

you mean pushing the flament in the hole? nope i cant.

After you raise the temperature properly but you can extruder the filament by your hand, you should check if the nozzle is jammed.

but when i push the filament with the right temperature it doesn t melt. and when i try to print something its like the extruder motor dosen t move at all.

After you raise the temperature properly but you can extruder the filament by your hand, you should check if the nozzle is jammed.

Sorry, I was to say"
After you raise the temperature properly but you can not extruder the filament by your hand, you should check if the nozzle is jammed."

Is the nozzle too close to the bed that the filament can not come out?
If not, please refer to this page to clear the nozzle:
http://www.geeetech.com/forum/viewtopic ... 19&t=16414

i tryed your link to clear my nozzle. i got the nozzle form the extruder raised the temperature to 240 degree and i tryed to push the filament. it came out a bit but after sometimes its just stoppend and pushing the filament it broke inside the nozzle .