Re: Z axis problem
Posted: Wed Aug 03, 2022 1:11 am
I look to the steper motors and they turn after layer change but i think they turn to little.
I changed the step motor controllers between z and x axis without success.
I used cura for the first time and the fine with 0.1mm also i try some gcodes but i dont know now which one. Before that everything was ok
I tried also a firmware reflash without success.
I think it is no mechanical problem only a software variable one.
Please help me what i can try and how to reset everything to factory defaults.
I changed the step motor controllers between z and x axis without success.
I used cura for the first time and the fine with 0.1mm also i try some gcodes but i dont know now which one. Before that everything was ok
I tried also a firmware reflash without success.
I think it is no mechanical problem only a software variable one.
Please help me what i can try and how to reset everything to factory defaults.