Geeetech

HI,

i recently bought 5 stepsticks like these: http://www.geeetech.com/wiki/index.php/ ... ver_Module

Im using them with a ramps 1.4 and arduino boards, the problem is that the maximum current i can get is 230mA when the potentiometer is all turned.

¿is there any solutions for this problem?

Thanks

Hi, friend
I am sorry for missing about adjust current in wiki. There is a knob that is a slide rheostat on board , the current will change when you adjust the knob.
If other problems ,please tell me.


Yours sincerely
techsupport

Hi ,friend
May you tell me model of the motor you used ? Have you other motors to test for the A4988 ?
Yourself sincerely
techsupport

Hi ,friend
I am so sorry for the late reply.
You know the current of A4988 shield matter the used motor.So I cann't sure the influence of you used motor.
If you have other motors for the test?

Yours sincerely
techsupport