Geeetech

Hi
Sorry for my poor english

I can't arrive to configure my firmware (repetier 0.91) for your lcd board with clickencoder+reset

I not arrive to control correctly the encoder.
When I turn the button, is as I push the button.
When I turn the encoder, some time, I can acced at the first page menu, but only the first.
I have tried to swap pin numbers in the firmware, but is same thing.

I think that clickencoder A and B pin are 31 and 33
And for the button, is 35.

Is right ?

Could'you help me please

Regards

Hi sykorsky

In order to better judgment and problem solving.
you'd better give me a picture of a it doesn't work.
In the Forum or Email to technical@geeetech.com

thank you