Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
https://forum.geeetech.com/

RAMPs issues.

https://forum.geeetech.com/viewtopic.php?t=16056

Page 1 of 1

RAMPs issues.

Posted: Fri Mar 06, 2015 12:45 pm
by vinnyboy13
I just finished setting up my printer and printed 2 things. Both of these prints failed so I decided to shut everything down and try again later. When I set everything backup I can connect to the printer and thats about it. Once I connect I am unable to send any command to the printer other then home. Everything I try all it does is stay idle. This is really confusing me since I printed to things just the other day.

168/3dprintersonlinestore.com <---- The printer I bought and assembled.

Re: RAMPs issues.

Posted: Fri Mar 06, 2015 2:03 pm
by zhangxueyou
Could you please tell me you printer type so that I could send you the corresponding firmware.
And please leave your email address.
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited