Arduino dead
Posted: Tue Mar 24, 2015 4:08 am
Just finish to assemble my Acrylic Pro Prusa i3(arduino+RAMPS), but the arduino is dead...only power led working...my pc don't see the arduino even as unknow device.
I have chose arduino + ramp elettronic because i've programmed variuos model of arduino, so i'm experienced enough to say that is dead...no signal from or to the USB.
I've tested all the other elettronic with an old arduino and a firmware that i wrote just to move the motor and seem good (i haven't tried to heat the bed and the hotend and the lcd because i didin't find a connection diagram online)
I wanna try to connect my arduino to ceck all but before installing a generic firmware (Merlin???) without the right configuration, i wrote here asking for the right firmware and what to do with the dead arduino.
I have chose arduino + ramp elettronic because i've programmed variuos model of arduino, so i'm experienced enough to say that is dead...no signal from or to the USB.
I've tested all the other elettronic with an old arduino and a firmware that i wrote just to move the motor and seem good (i haven't tried to heat the bed and the hotend and the lcd because i didin't find a connection diagram online)
I wanna try to connect my arduino to ceck all but before installing a generic firmware (Merlin???) without the right configuration, i wrote here asking for the right firmware and what to do with the dead arduino.