Page 1 of 1
sanguino does not show in Arduino
Posted: Tue Mar 24, 2015 7:59 am
by szeiger
How do we get the sanguino board to show up in Arduino/tools/board? the directions in one place say to move "sanguino" into arduino/hardware, but where do we get that file from?
Re: sanguino does not show in Arduino
Posted: Tue Mar 24, 2015 3:17 pm
by zhangxueyou
You can refer to this page:
http://www.geeetech.com/wiki/index.php/ ... _To_set_up
You can find the "sanguino" folder under "hard ware" in the installation directory of Arduino IDE.
Re: sanguino does not show in Arduino
Posted: Tue Mar 24, 2015 10:45 pm
by szeiger
the sanguino file does not show up in the arduino directory. Where can I download it from?
Re: sanguino does not show in Arduino
Posted: Wed Mar 25, 2015 1:20 am
by szeiger
Ok, that link helped me get the right Repetier Host software. I apoligize for not reading the instructions carefully enough. Now I just need to get the sanguino file into Arduino to upload the firmware file to the machine.
Where do I find the sanguino file?
Re: sanguino does not show in Arduino
Posted: Wed Mar 25, 2015 4:01 am
by szeiger
resolved
Re: sanguino does not show in Arduino
Posted: Wed Mar 25, 2015 8:58 am
by zhangxueyou
Hi, you can see the first post at this page:
http://www.geeetech.com/forum/viewtopic ... 14&t=16097
There is download link for Sanguinololu.