Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
https://forum.geeetech.com/

X Y Z axis for those new to 3d printing

https://forum.geeetech.com/viewtopic.php?t=16124

Page 1 of 1

Tips and tricks website

Posted: Wed Mar 25, 2015 9:20 pm
by szeiger
Found this site while looking for some answers: reprapsquad.wordpress.com
Worth checking out

X Y Z axis for those new to 3d printing

Posted: Thu Mar 26, 2015 1:29 am
by szeiger
Most of the problems I have had were related to not having X and Y configured correctly. If you are having trouble with the stop switches and homing, make sure X, the carriage that moves left and right, and Y, the hotbed/glass are plugged into the correct spots on the Sang board, with the X being towards the front of the printer, and then Y, Z, and then extruder.

Hope this helps someone.

Scott

Re: X Y Z axis for those new to 3d printing

Posted: Thu Mar 26, 2015 9:28 am
by zhangxueyou
Thank you for sharing.
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited