Page 1 of 1
end stops
Posted: Sat Mar 28, 2015 12:30 am
by darxide
Have been trying to get endstops working. I have both z and y is order but I cant get y to operate tried switching wires switchs and strait up unplugging it.... could the onboard resistor b dead?
Re: end stops
Posted: Sat Mar 28, 2015 11:08 am
by zhangxueyou
Did you upload the firmware I sent you and connect the enstops correctly?
- QQ截图20150328110527.png (554.67 KiB) Viewed 6063 times
Re: end stops
Posted: Sat Mar 28, 2015 11:30 am
by darxide
Yes ive tried the x on both high and low and get no response from switch when I run m119
Re: end stops
Posted: Sat Mar 28, 2015 2:07 pm
by zhangxueyou
Sorry, I don't get your point. Please speak standard English.
You'd better take some photos, or take a video.