Page 1 of 1

LCD2004 not displaying

Posted: Thu Apr 02, 2015 12:20 am
by caanukle
the firmware I was emailed didn't work on my Acrylic Geeetech I3 pro 3D Printer but I was able to edit the default marlin files from your instructions and other information I found to get the axis and endstops working.

the problem now is that my LCD2004 still does not display. I had it flickering once when playing around within marlin but I thought I could get some better information here.

I am also waiting on a replacement heater cartridge and the one that was shipped was faulty and you failed to reply to my email so I just ordered a replacement without waiting for a reply.


so far my experience with getting my printer running has been a learning experience but communication and firmware has been a little frustrating.

thanks
caanukle@gmail.com

LCD2004

Posted: Thu Apr 02, 2015 8:39 pm
by caanukle
The firmware you emailed me doesn't work. it uploads but I can't connect to the printer in Rerpetier, or at least nothing works when I do.

when I follow these instructions (http://www.geeetech.com/wiki/index.php/ ... le_Burning) but leave out "delete the “//” from “//#define REPRAP_DISCOUNT_SMART_CONTROLLER” to ensure the normal working" it uplaods and I can connect fine and control the printer using manual control. when I uncomment that line, upload and try to connect nothing happens.

attached is my working firmware without the LCD working

thanks
caanukle@gmail.com

Re: LCD2004 not displaying

Posted: Fri Apr 03, 2015 4:03 pm
by zhangxueyou
Try this:
PI3B-ramps.rar
(229.7 KiB) Downloaded 416 times