Geeetech

Hi.

Just finished assembly of my acrylic prusa I3.

The Z axis is going the right way (down when pressing home)

But the Y axis and the Z axis are going in the opposite of the endstops.
I tried both repetier and the control panel.
What do I do?
inverts cables?

thanks for your reply

Yes, you can try to invert cables.

Ok.

Do I invert it by pairs? do i also invert colors?

thanks.

Invert the cable of motor which goes wrong way.

Ok.

So the wires are actualy
Black - Green - Red - Blue.

How do i invert it?

Blue - Red - Green - Black?
or
Red - Blue - Black - Green?

Yes , blue,red,green,black.
Just unplug the cable, roate it for 180°, and plug it.

The sockets are equipped with a "keyed system" (<-Google trad?), so I had to make a small adapateur but that's it, it works!

Thank you! Problem solved.

A problem once, now I'll find out why the extruder does not work manually.

The extruder motor can not move unless the temperature of extruder is more than 175 degrees.

in Repetier_host under the printer settings / Printer shape you can change the home location on the ones you think is driving the wrong way