Geeetech

Posted: **Sat May 02, 2015 5:08 am**

Hello,
I'm trying to get the TemperatureWebPanel working for now about 2 days, but it simply wont work.
I've created the directory arduino/www/ on my USB-Flash, also the bridge is working, but if I want to open "http://YUN_IP/arduino/temperaturewebpanel/ the only thing I see is an empty page ...

I would be very happy, if you could help me!

Leon

Posted: **Mon May 04, 2015 11:33 am**

You can refer to this page, hope it will help you:
http://www.geeetech.com/wiki/index.php/ ... nt.2Fsd.3F

Posted: **Tue May 05, 2015 12:20 am**

Of course I've already read that one, but it doesn't help...

Posted: **Tue May 05, 2015 3:04 pm**

You must have something left out. The tutorial in wiki was tested before posted.

Posted: **Sun Feb 21, 2016 12:24 am**

I too cannot use USB stick.
I have enabled mount point and Iduino had recognised my stick as it was offered in a drop-down.
Mount point is not shown as connected
Stick is prepared with required directories but nothing is loaded when I upload TemperatureWebPanel

Your Wiki is very weak on this point, it suggests USB is mounted automatically without any setting, please improve this tutorial

Geeetech

Iduino Yun Shield - Can Not Use The USB-Flash

Iduino Yun Shield - Can Not Use The USB-Flash

Re: Iduino Yun Shield - Can Not Use The USB-Flash

Re: Iduino Yun Shield - Can Not Use The USB-Flash

Re: Iduino Yun Shield - Can Not Use The USB-Flash

Re: Iduino Yun Shield - Can Not Use The USB-Flash