Page 1 of 1
Profile for Me Ducer
Posted: Wed May 13, 2015 2:23 pm
by armandozzz
Hi
I just buy a printer ME DUCER. I must will download the Repetier Software but i want to know if there are any profile to print PLA with 100microns quality.
Anyobody use Cura?
Thanks
Re: Profile for Me Ducer
Posted: Wed May 13, 2015 3:15 pm
by zhangxueyou
Repetier download link
http://www.repetier.com/download-now/
Unless your nozzle diameter is not more than 200 microns, otherwise you can't print with 100 microns quality.
Re: Profile for Me Ducer
Posted: Wed May 13, 2015 3:35 pm
by armandozzz
if i change the hotend by one of 0.3mm i will have more preccision?
Re: Profile for Me Ducer
Posted: Wed May 13, 2015 3:54 pm
by zhangxueyou
The lower nozzle diameter , the more precison you have.
Re: Profile for Me Ducer
Posted: Wed May 13, 2015 7:45 pm
by armandozzz
can you send a good setting for me Acrylic ME DUCER 3D printer? thankss alll!
Re: Profile for Me Ducer
Posted: Wed May 13, 2015 7:47 pm
by armandozzz
I want to Print PLA, can you send me the good setting? thanks
Re: Profile for Me Ducer
Posted: Thu May 14, 2015 9:16 am
by zhangxueyou
You can go to this page for referring:
http://www.geeetech.com/forum/viewtopic ... 14&t=16366
Slicer software is slic3r.
Re: Profile for Me Ducer
Posted: Thu May 14, 2015 1:58 pm
by armandozzz
slicer settings(1.75mm-0.3mm).zip
the ME DUCER have 1.75mm- 0.4mm. are you sure with this settings?
Re: Profile for Me Ducer
Posted: Thu May 14, 2015 2:08 pm
by zhangxueyou
Ofcourse you have to change some parmeters, you can see what I said in that topic.
Re: Profile for Me Ducer
Posted: Thu May 14, 2015 2:15 pm
by armandozzz
perfect thanks my friend