Geeetech

Posted: **Fri May 15, 2015 9:22 pm**

Hi,

After first power on, just assembled geeetech prusa i3 printer, on the LCD I see strange characters. Look at the pictures attached. Double checked all solder pins on LCD PCB and on cable adapter, no problems found.
Can some body to advice?

Posted: **Mon May 18, 2015 9:04 am**

How about swapping the connection of 2 cables?

Posted: **Mon May 18, 2015 1:39 pm**

The cable swaping did not help.
The problem was, wrong LCD type selection while upload firmware.
The problem solved by reloading firmware and defing #define REPRAP_DISCOUNT_SMART_CONTROLLER

Posted: **Wed May 27, 2015 8:54 am**

Can you show how you got it to work..step by step ..total newb here??

Geeetech

LCD 2004 Garbage on

LCD 2004 Garbage on

Re: LCD 2004 Garbage on

Re: LCD 2004 Garbage on

Re: LCD 2004 Garbage on