Error "Extruder switched off. MINTEMP triggered"
Posted: Thu May 21, 2015 2:56 am
Using the GT2560 board, allows up to two extruders, but I only have one.
I measured voltage and resistance of the thermosister. I get Around 4.8V and around 80Ohms..
When I test for continunity I get no beeps from the thermosister. I think this is normal. The same goes for the heat bed thermosister.
In addition, when I attempt to heat the heatbed, nothing happens...
I measured voltage and resistance of the thermosister. I get Around 4.8V and around 80Ohms..
When I test for continunity I get no beeps from the thermosister. I think this is normal. The same goes for the heat bed thermosister.
In addition, when I attempt to heat the heatbed, nothing happens...