Geeetech

When comparing the board diagram on the wiki page to the build instruction the connections of heating element and thermosister of Extruder 1(or 0) and extruder 2(or 1) are opposite..
the connections of the motor do match.


http://www.geeetech.com/wiki/index.php/GT2560


http://www.geeetech.com/Documents/Acryl ... uction.pdf

Would just like to notify the public in case of confusion..

I assume the wiki page on the GT2560 is the correct one..

Yes, you are right. We will correct it. Thank you for your reminding.

Connections of thermistors are correct.