Page 1 of 1
Extruding too much! Ask for 5mm get 50mm
Posted: Sun Sep 13, 2015 10:20 am
by XYZM
Sounds like a simple fix, can any one help.
Thank you
Re: Extruding too much! Ask for 5mm get 50mm
Posted: Wed Sep 16, 2015 7:51 pm
by Mark
What's your printer type? and what's the E steps per mm in your malin firmware?
Re: Extruding too much! Ask for 5mm get 50mm
Posted: Wed Sep 16, 2015 11:47 pm
by XYZM
It ended up being the steps on my driver. So its closer to range, just now it seems to be not as thick as before though.
I am set to 95 steps in the software
Re: Extruding too much! Ask for 5mm get 50mm
Posted: Wed Sep 16, 2015 11:48 pm
by XYZM
I have the i3 B with the GT2560 board and MK8 extruder.
Do you recommend a better type of extruder for future use?