defective part Extrieder Holder
Posted: Tue Nov 03, 2015 9:39 pm
My Extruder Holder cracked along the filaments between the holes . . I was wondering why I had to keep tightening the 2 4 mm screws which hold it to the "X" Axis . .
https://www.facebook.com/photo.php?fbid ... 164&type=3
Need new Extruder Holder Eric suggested this one
http://www.geeetech.com/mk8-dual-extrud ... p-950.html
https://www.facebook.com/photo.php?fbid ... 164&type=3
Need new Extruder Holder Eric suggested this one
http://www.geeetech.com/mk8-dual-extrud ... p-950.html