Printing off
Posted: Sat Nov 14, 2015 9:43 am
- Photo on 11-13-15 at 7.40 PM.jpg (58.24 KiB) Viewed 7515 times
Geeetech
Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
https://forum.geeetech.com/
Printing off
Page 1 of 1
Whenever I try to print after a couple of layers the extruder no longer lines up with the beginning of the print
Re: Printing off
Posted: Sat Nov 14, 2015 10:33 am
Do you mean your Y or X aixs is skipping setps? maybe you can leave a youtobe link here to see what happens.
And you can refer to the link here to check the driver voltage:
http://www.geeetech.com/forum/viewtopic ... 13&t=17038
And you can refer to the link here to check the driver voltage:
http://www.geeetech.com/forum/viewtopic ... 13&t=17038
Re: Printing off
Posted: Tue Nov 17, 2015 9:57 am
Yes, it is the x axis shifting. I have tried changing the driver voltage it doesn't change, it stays at 5.04.
Re: Printing off
Posted: Tue Nov 17, 2015 10:04 am
I checked, all the drivers show the same voltage, but only the x is skipping
Re: Printing off
Posted: Tue Nov 17, 2015 5:53 pm
No, not the 5V one, you need to adjust the voltage through the potentiometer here, and increase it to about 0.9V.
- A4988 voltage.jpg (217.64 KiB) Viewed 7477 times
Re: Printing off
Posted: Tue Nov 17, 2015 10:13 pm
HI,
Yes, I am aware of the correct place to make adjustments. It seems as though it is the bearings on the belt tensioner. When I took it apart one side fell completely apart. I figured if one better check the other, so both the x and y tensioner had the same problem. The bearings were broken on both of them. I will post pictures tonight when I get home again.
jb
Yes, I am aware of the correct place to make adjustments. It seems as though it is the bearings on the belt tensioner. When I took it apart one side fell completely apart. I figured if one better check the other, so both the x and y tensioner had the same problem. The bearings were broken on both of them. I will post pictures tonight when I get home again.
jb