Can anyone suggest a simple first item to print
Posted: Sat Nov 21, 2015 10:16 am
Hi
Just wondering if anyone can suggest a simple item that is suitable for the first item to print. I wish to verify that i can get the machine to operate under its own control (i have only used manual controls thus far in Repetier host). I tried to print a calibration cube that i downloaded however had no sucess at all, it moved one axis and that was it, I am new to all things programming and I am not exactly sure that if i would need to change the G-code.
Looking for suggestions for a simple item that can get me up and running on my Aluminium I3 printer. That way i can see easier which issues i need to attend to.
Any suggestions are greatly appreciated
Regards
Shaun
Just wondering if anyone can suggest a simple item that is suitable for the first item to print. I wish to verify that i can get the machine to operate under its own control (i have only used manual controls thus far in Repetier host). I tried to print a calibration cube that i downloaded however had no sucess at all, it moved one axis and that was it, I am new to all things programming and I am not exactly sure that if i would need to change the G-code.
Looking for suggestions for a simple item that can get me up and running on my Aluminium I3 printer. That way i can see easier which issues i need to attend to.
Any suggestions are greatly appreciated
Regards
Shaun