Page 1 of 1
Printing
Posted: Fri Jan 01, 2016 10:26 am
by swt7
OK. I have built the printer. I have calibrated it. I tried to print and the printer went nuts on me. It slammed against the the upper limit switches and then slammed against the print bed. Did I do something wrong. I'm new to 3d printing. I am using the GEEE TECH mini G2s. I am printing the first print with one extruder .
Re: Printing
Posted: Tue Jan 05, 2016 8:56 pm
by Mark
did you delete the G29 from the slic3r settings? if not,you'll get the wierd behaves, and remember to home the printer first when you turn it on!
Re: Printing
Posted: Wed Jan 20, 2016 9:45 pm
by swt7
Sorry it took so long to get back to you. Yes it had the G29. I removed it and it worked fine.
Thank you for your help.