Page 1 of 1

Err: MINTEMP BED

Posted: Fri Jan 15, 2016 9:15 pm
by river2000sg
Hi,
I just assembled my G2S pro. I've installed Arduino and uploaded firmware successfully.
I have a problem which is : Err; Mintemp bed in LCD display. I only connected the board to windows. Main power not on.
with this error on, I am unable to home X/Y/Z motor.
Please help. Thanks.

Re: Err: MINTEMP BED

Posted: Fri Jan 22, 2016 12:10 am
by Mark
does your thermistor plugged in the correct connector? If it is then check this link:
http://www.geeetech.com/forum/viewtopic ... 23&t=17030

Re: Err: MINTEMP BED

Posted: Thu May 19, 2016 8:06 pm
by andy01842
" I only connected the board to windows. Main power not on. "
you need the main power to heat and drive the motors etc