Geeetech

hi iam having problems with my settings on my printer esteps or calibration i dont really know.

What settings do you guys use on your printers?

it should be the same on all printers right? well all geeetech i3 prusa acrylic

here is a example

the E steps, you can make a mark on the filament, manually extrude 50mm through the repetier host and compare it to the actual feed length to increase or decrease the steps to a proper value.

thanks mark!
how about the steps for xyz axis?

they are the same, measure the actual dimensions of the object and then calibrate X Y Z steps.