Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
https://forum.geeetech.com/

Geeetech Prusa I3 M201, heat sink and Ejector pin

https://forum.geeetech.com/viewtopic.php?t=17574

Page 1 of 1

Geeetech Prusa I3 M201, heat sink and Ejector pin

Posted: Mon Mar 07, 2016 8:51 pm
by BarryT
When i was building my Geeetech Prusa I3 M201. I also got 5 small heat sinks. And i don't know where i have to place them. And are the blue stickers there to glue the heatsinks?
I also got a "Ejector pin" and i don't what i can/should do with it.

Kind regards,
Barry

Re: Geeetech Prusa I3 M201, heat sink and Ejector pin

Posted: Mon Mar 07, 2016 9:05 pm
by Mark
yes you're right, use the glue stickers to stick the heatsink on the drivers to help them cool down. And the ejector pin is used to clean the hotend when it's clogged, check out this link:
http://www.geeetech.com/forum/viewtopic ... 19&t=17097
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited