Geeetech

I have built and calibrated manually the G2s Pro, printed a couple of products, but so far I have been unable to run the auto bed levelling.
I have the Geeetech version of Marlin and running through Repetier Host. I have the probe limit set on Z min to the to the GT2560 control board.
Do I need to make some changes in the Marlin Firmware? and what G codes do I need to run in order to use the auto bed levelling.

Did you get the quicker starter manual? it will tell you how to do this, you can download it here:
http://www.geeetech.com/delta-rostock-m ... p-936.html

Thanks Mark, no I didn't receive that link or manual, will go through that. cheers