Page 1 of 1
Print Offsets
Posted: Fri Apr 01, 2016 6:35 am
by Kimbleos
I3 M201 printer. The print starts and lays down the first layer then lays down another layer about a quarter of and in to the front of the first. So it looks like it started over about a quarter of an inch in front of the first. Have rechecked all settings numerous times, nothing seems to work.
Re: Print Offsets
Posted: Fri Apr 01, 2016 11:33 am
by Mark
seems like the motors are skipping steps, how's the driver voltage? is it proper? you can check it according to this link:
http://www.geeetech.com/forum/viewtopic ... 17&t=17038
Re: Print Offsets
Posted: Fri Apr 01, 2016 11:22 pm
by Kimbleos
The voltage for all axis were at about .57v. Put them to 1.0v and that fixed that problem. Should the extruder motors be set to .87v-1.2v also?
Re: Print Offsets
Posted: Sat Apr 02, 2016 10:59 am
by Mark
yes, set all of them to about 1.0V, expecially the Z axis and extruder motors, they need more power to work properly.