Geeetech

hi

i see the on the manual that say
x -is set to 280 see picture #2 please, its mistake no? 280mm is the z i think

and why the check box of the mixing extruder not check ? see picture #1 please
the m201 is with mixing extuder


thanks
yossi

the heatbed is 280*210, so the X is 280 and Y is 210. Z axis is the one that moves up and down.

thanks

and what about #2?


why the check box of the mixing extruder not check V ? see picture #1 please
the m201 is with mixing extuder

SO ITS NEED TO BE WITH v INSIDE THE CHEC BOX NO?

not clearly about this option too, but don't need to select this option on M201, so far so good.