Geeetech

hello

i wonder if there are here some peple with lot experince with blue tape / kapton tape ?
so once and for all can tell what is better for PLA and for abs

blue tape ot kapton tape for each other
or one of them with ABS juice ?


thanks
yossi

I use just about any Masking tape/ Blue tape I can get for PLA at 60 Deg.C. on top of a glass bed for PLA . Kapton tape is for HiTemp use ,like hotend insulation and ABS .
Kapton tape is also a good base if you do not have a glass bed , the masking tape peels off of Kapton cleaner than a plane Al. bed .

Thanak

So ehat is the best method to print abs ?

Thanks
Yossi

The best way to start is to build an enclosure for your printer.

thanks.
i realy start to think about it
i will do build one, but the pcb boars need to be ouside the heat !! else it will be so hot there